Perryville, MD HVAC Specialists

We successfully addressed the issue with the closet doors, which were previously not functioning properly due to being off the track and prone to falling. We meticulously remounted the doors, ensuring they were securely aligned. Additionally, we repaired the track and the peg latch mechanism, restoring full functionality. The customer was thoroughly satisfied with the improvements and expressed her happiness. The job was completed without any payment required.

Upon arrival, both rooftop units were operational. I conducted a thorough evaluation with GM Paul, performing an extensive quality check. The older unit's air movement system was disassembled, cleaned, and re-calibrated, achieving a .7iwc total static pressure. The refrigerant charge was verified, and the system operated efficiently with a 20⁰F deltaT. The new unit was also evaluated, achieving a.9iwc total static pressure and a 19⁰F deltaT. Both systems met manufacturer specifications, with no leaks or clogs. The units were set back to their schedules at 85⁰F. The roof was cleaned, and all doors were locked.

WO-TNFR687769 I replaced the condensate water removal system and reconnected the 3/4-inch condensate drain. After installation, I performed a leak check and found no leaks. During testing, I discovered that the main heat transfer media coil was not channeling condensate water properly due to debris buildup. I applied an approved cleaner to break down and remove the dirt and debris, restoring proper condensate drainage. I verified the system was operating correctly, with the condensate drain functioning properly.

I conducted a thorough maintenance check on the AC components of an oil furnace. Initially, the Delta T was 18 degrees, but it increased to 19 degrees after running for over five minutes. I replaced the filter and labeled it with the current date. Voltages and amps at the indoor unit were within acceptable limits, with fan motor amps at 5.31 and 5.24. The indoor voltage enhancement system was operating at 9.93 mfd within the 10mfd range. I cleaned the air handler with a suitable cleaner. The outdoor unit was tested in cooling mode, showing 120v on leg one and 121v on leg two, totaling 241v with no voltage loss. The compressor received 120v, and amp readings were 4.24 for start, 5.07 for run, and 4.61 for common. The outdoor voltage enhancement system was at 34mfd and 5mfd within the 35/5mfd range. Unfortunately, the homeowners' hose spout was broken, preventing coil spraying, though minimal debris was observed in the fins.

I meticulously cleaned the return box, ensuring all dust and debris were removed. Using specialized vacuum equipment, I carefully navigated the intricate components to avoid any damage. The process involved thorough inspection to confirm complete removal of contaminants. This ensured the return box was in optimal condition for its next use, maintaining the integrity and efficiency of our operations. Precision and attention to detail were paramount throughout the task.

I successfully replaced a malfunctioning 2 Hear 2 Cool thermostat. The initial issue was that the thermostat was not regulating the temperature correctly, leading to discomfort and potential energy inefficiency. I carefully removed the old thermostat, ensuring all wiring was disconnected safely. After confirming the model and compatibility, I installed the new thermostat, connecting all necessary wires and components. I then calibrated the settings to match the homeowner's preferences and preferences. The new thermostat is now functioning perfectly, providing accurate temperature control and enhancing overall comfort. This replacement comes with a full warranty, ensuring peace of mind for the homeowner.

During the inspection, a fault was identified in the water removal system. Upon further evaluation, a crack in the condensate collector pan was discovered, causing condensate water to leak into the return air box and saturate the air filter. This issue, if left unaddressed, could lead to reduced airflow, water damage, and potential indoor air quality concerns. The condensate collector pan requires replacement to resolve the problem. Currently, the system is operational, but condensate water continues to drip onto the air filter and into the return air box until the repairs are completed.

We conducted a thorough cleaning and inspection of the air conditioning system, focusing on both indoor and outdoor units. This included cleaning the evaporator and condenser coils, and unit cabinets to ensure optimal airflow and efficiency. We inspected all wiring and electrical connections, tested condensate drains and safety controls, and operated the system in both cooling and heating modes. The UV system bulb was replaced, and the filter was recommended for replacement. All systems are now operating within normal specifications.

I successfully replaced a malfunctioning controller as per the work order. Upon inspection, the previous controller was found to be non-functional, leading to operational issues. I carefully removed the defective unit and installed a new, high-quality controller. Following the installation, I conducted thorough testing to ensure that all systems were operating correctly. The new controller was configured to meet the specific requirements of the equipment, and all tests confirmed that the system was fully functional. The client was informed of the successful replacement and the satisfactory outcome of the tests.

I performed a thorough cleaning and inspection of the air conditioning system, focusing on both the indoor and outdoor units. The evaporator and condenser coils, along with the unit cabinets, were cleaned to ensure optimal airflow and heat transfer efficiency. All high- and low-voltage wiring and electrical connections were inspected and found to be secure with no visible defects. The condensate drains and safety controls were tested and verified to be functioning correctly. The system was operated and tested in both cooling and heating modes. The outdoor unit's voltage enhancement system and voltage enhancement device had failed, which were replaced and tested. All components are now operating within normal manufacturer specifications, and this repair comes with a one-year limited warranty.

I conducted a thorough cleaning and inspection of the air conditioning system, focusing on both the indoor and outdoor units. The evaporator and condenser coils, along with the unit cabinets, were meticulously cleaned to ensure optimal airflow and heat transfer efficiency. All high- and low-voltage wiring and electrical connections were inspected, found to be secure with no visible defects. The condensate drains and safety controls were tested and verified for proper operation. The system was operated and tested in both cooling and heating modes. The voltage enhancement system showed a 45/5 reading and failed at relief, prompting a recommendation for a voltage storage device and enhancement system. The drain lines were cleared of debris, and pan treatment was installed. Indoor unit readings showed a Delta T of 22°F, and the coil pass was clear of debris. The heat exchanger passed the smoke and visual inspection. The filter was changed, and all safeties passed.

Today, I conducted a thorough cleaning and inspection of the air conditioning system, including both the indoor and outdoor units and a single-zone mini-split system. I cleaned the evaporator and condenser coils, unit cabinets, and inspected all wiring and electrical connections, which were secure and defect-free. I tested the condensate drains and safety controls, ensuring proper operation. The systems were tested in both cooling and heating modes. I also cleared debris from the drain lines, installed pan treatment, and recommended a UV system for improved indoor air quality. All components operated within normal specifications.

See other invoice

Upon receiving the task, I began by diagnosing the issue with the STAT system, which was not providing the expected cooling option. After thorough investigation, it was discovered that the STAT unit was unresponsive. Further analysis revealed that the voltage monitor was faulty, preventing the STAT from functioning correctly. I bypassed the problematic voltage monitor to restore functionality. With the STAT system now operational, the cooling option was successfully activated, ensuring the system was back up and running efficiently.

I conducted a thorough rejuvenation of the heat pump system, focusing on optimizing its performance. After testing the cooling mode, it was evident that the system was inefficient, with a Delta T of 9, indicating minimal temperature change. The outdoor unit displayed clear signs of impending failure. Given the unit's age of 36 years, I recommended replacement options. During the site visit, Jason and I reviewed potential replacements to ensure the system's future efficiency and reliability.

I replaced the existing thermostat with a wifi-enabled model, ensuring all connections were secure and accurate. I tested the system to confirm all operations were running normally, achieving a 20° delta T. The evaporator was observed to be condensing and draining properly. The unit operated until the thermostat was satisfied. Unfortunately, the homeowner was not present to install the app and learn its usage, so I informed his wife to contact me if he has any questions. The job was completed without any issues.

club renewal

I performed a comprehensive Club Cleaning on the Amana S-Series Air Handler, Model AHVE36CP1400AA, Serial 2306073553. I inspected and serviced the system, measuring the line voltage at 246V. The ECM blower motor and circulation blower wheel were checked, with the wheel found generally clean. I cleaned the main indoor heat transfer coil, condensate drain pan, and EZ-Trap assembly, and verified the overflow safety switch. The 20x20x1 air filter was clean. I also inspected the Solaceaire UV purification system, recommending a UV bulb replacement every 2 years. The system temperature split Delta T was 20°F, indicating acceptable performance. The outdoor heat transfer coil was cleaned, and all electrical connections were secure.

I successfully managed the renewals and sign-ups for the club, working closely with Amanda. This involved coordinating with members to ensure their memberships were updated and new members were smoothly onboarded. I handled communication, processed renewals, and provided support to ensure a seamless experience. My efforts contributed to maintaining and growing the club's membership base effectively.

I conducted a thorough maintenance on the AC components of a gas furnace. The Delta T was 17 degrees initially. The filter was replaced due to clogging with dust and dirt, which had also entered the blower cabinet. Voltages and amps were within acceptable ranges. The condensate removal system functioned correctly, and the condensate line was cleared of debris. The air handler and indoor coil drain pan were cleaned. I recommend blower cleaning and a new pan treatment. The outdoor unit operated in cooling mode without any error codes. The coil was cleaned with a solution to remove clogged fins.

I successfully completed the replacement of the front panel on the indoor head of a Mini Split system. The process began with a thorough inspection of the existing unit to identify any issues with the old panel. After confirming the need for replacement, I carefully removed the old panel, ensuring no damage to the surrounding components. I then installed the new front panel, making sure it was securely attached and aligned properly. Post-installation, I tested the system to ensure the new panel functioned correctly and efficiently. The job was completed to the highest standards, restoring the unit's performance and appearance.

I completed a Gold Club AC Rejuvenation service, which involved a thorough inspection, cleaning, and maintenance of the air conditioning system. I replaced necessary filters, checked refrigerant levels, and ensured optimal performance. The customer was impressed with the results and decided to sign up for a Gold membership, gaining access to exclusive benefits and services.

I recently completed a comprehensive home maintenance project, which included repairing a leaky faucet in the kitchen and replacing the outdated lighting fixtures in the living room. The faucet was meticulously disassembled, inspected, and reassembled to ensure a perfect seal. In the living room, I removed the old fixtures and installed modern, energy-efficient LED lights, enhancing the room's ambiance. Additionally, I performed a thorough inspection of the electrical systems to ensure safety and compliance with current standards.

I completed a comprehensive rejuvenation of two AC systems. Both indoor and outdoor units were thoroughly cleaned and tested. Repair recommendations were provided for all units. The voltage enhancement systems were out of range, impacting efficiency and potentially causing future issues, but this has been resolved. Surface rust was detected on the primary drain pan in the attic, though safety switches are in place. A deep cleaning of the indoor air circulation system was also performed. Four repairs were made, ensuring cost savings and preventing future service calls.

No AC. Filty was dirty. Customer replaced it before arrived but sent me a picture. Found voltage distributor failed. Replaced and he signed up for the Gold Club. Checked operations. All operations running normal WO-TNFR659903