Recent Jobs and Reviews in Port Deposit, MD
Job Locations and Reviews
I performed a thorough maintenance check on the AC system, focusing on the gold club. Although the Delta T wasn't accurately checked due to the absence of nearby ducts, it reached 15 degrees. The filter was in good condition and didn't require replacement. I cleaned the air handler and indoor coil drain pan. The condensate line was flushed but showed signs of blockage, suggesting a small pan treatment. The evaporator coil and blower wheel were clogged with debris, necessitating deeper cleaning. The outdoor unit operated in cooling mode, with voltages and amps within acceptable limits. The outdoor coil was cleaned with water.
Upon inspection, the air conditioning system was found to be non-operational. The voltage relay for the compressor was identified as the failure point. Additionally, a burned-up mouse was discovered over the contactor, obstructing the switch from engaging. The faulty relay was replaced, and the contactor was cleared of debris. Following these repairs, all system operations were verified to be functioning normally, with a Delta T of 20 degrees recorded.
WONTFR676150.
club renewal
Upon arrival, I identified a disconnect that had been unplugged. After reconnecting the unit, it powered on successfully. The compressor was operational, drawing 15 amps, which is within the expected range of 21 RLA. To ensure stability, I unplugged the power supply, allowed the unit to rest for a brief period, and then reconnected it. The unit started without issues, indicating that the problem was resolved. The work order number for this job was WONFTR674837.
Upon arrival, the air conditioning system was not functioning properly. A thorough inspection was conducted to identify the issue. A detailed leak search revealed a very small leak at the service valves. The repair was executed without breaking the charge, ensuring minimal disruption. The system was recharged with 5oz of 410A refrigerant. After the repair, the unit was started, and operational checks were performed. The system was observed to be running normally, with a delta T of 20⁰ and proper condensation. A final verification confirmed no further leaks were present. The job was completed successfully, ensuring the system operates efficiently. WO-TNFR673396.
Upon receiving the call, I began by thoroughly inspecting the air conditioning equipment to identify any potential issues. Despite not finding any error codes, I continued to examine the system for any abnormalities. After a comprehensive check, no issues were detected. I then guided the customer through the process of resetting the unit. Following this, the system began operating normally. To prevent future issues, I advised the customer to document any error codes they might encounter. The customer has reported that the AC has been running smoothly for the past couple of days.
I conducted a thorough maintenance check on the AC components of the gas furnace. Initially, the delta T was slightly low at 16 degrees, but after the unit operated for over 15 minutes and the outdoor coil was cleaned, it improved to 20 degrees. The air filter did not require replacement. I cleaned the inside of the air handler with an appropriate cleaner and flushed the condensate line to remove any debris. The indoor coil drain pan was already clean, but I recommend applying a small treatment to it for preventive maintenance. The outdoor unit operated in cooling mode, with voltages and amps within acceptable ranges. I also sprayed the outdoor coil with water to remove any trapped debris in the fins.
Upon inspection, the outdoor unit was not operational. No error codes or alarms were present on the Buck booster. I restarted the unit, which then functioned correctly. I reviewed the alarm history, which did not indicate when the issues occurred. Photographs of the faults were taken for future reference. This documentation will aid in identifying any recurring problems during subsequent visits.
I successfully installed a sophisticated main voltage conversion system, complete with integrated voltage monitoring, surge protection, and rectification components. The incoming line voltage was measured at 249V, which was then effectively conditioned and stabilized by the new system, resulting in a clean and consistent operating voltage of 232V. I meticulously cleaned and secured all electrical connections, ensuring the integrity of the wiring. Following installation, I conducted thorough tests to confirm that all components were functioning as intended. The system operated properly and within normal parameters upon completion of the service.
Recently, I successfully completed a project that involved creating a custom art form. The task began with a detailed estimate, which outlined the scope and materials needed. After the estimate was approved, I moved on to the construction phase, meticulously crafting the art piece to meet the client's specifications. Throughout the process, I ensured that every detail was attended to, from selecting the right materials to executing the final touches. The project was completed on time and within budget, and the client was extremely satisfied with the final result. This project not only showcased my artistic skills but also my ability to manage time and resources effectively.
HVAC Professional Service Summary
Found system with several error codes stored in system history. System is faulting on over-voltage protection and shutting down as designed by the voltage monitoring device. Incoming line voltage is fluctuating between 248V and 250V. Over-voltage protection is set at 5%.
System requires installation of a rectifier/power conditioning device to help correct dirty voltage being supplied to the heat pump system from the home’s main electrical panel. This condition is being caused by the incoming electrical supply and is not considered a manufacturer defect or equipment failure.
At this time, the system is operating as designed under the existing electrical conditions.
club renewal
Club AC cleaning: delta T is 14 degrees. Air filter dirty. Customer will replace filter. Indoor fan is clean. Indoor fan amps 5.3. Leak searched indoor and outdoor coils and found no leaks. Outdoor RLA rated 17.1 amps actual is 9.3. Outdoor FLA amps rated 1.7 actual is 1.1. Outdoor voltage enhancement system rated 45/10mfd actual is 41.5/9.1. Voltage enhancement system is out of factory spec. Recommend replacing voltage enhancement system.
Club AC cleaning: delta T is 14 degrees. Air filter dirty. Customer will replace filter. Indoor fan is clean. Indoor fan amps 5.3. Leak searched indoor and outdoor coils and found no leaks. Outdoor RLA rated 17.1 amps actual is 9.3. Outdoor FLA amps rated 1.7 actual is 1.1. Outdoor voltage enhancement system rated 45/10mfd actual is 41.5/9.1. Voltage enhancement system is out of factory spec. Recommend replacing voltage enhancement system.
Club AC cleaning: delta T is 14 degrees. Air filter dirty. Customer will replace filter. Indoor fan is clean. Indoor fan amps 5.3. Leak searched indoor and outdoor coils and found no leaks. Outdoor RLA rated 17.1 amps actual is 9.3. Outdoor FLA amps rated 1.7 actual is 1.1. Outdoor voltage enhancement system rated 45/10mfd actual is 41.5/9.1. Voltage enhancement system is out of factory spec. Recommend replacing voltage enhancement system.
Club AC cleaning: delta T is 14 degrees. Air filter dirty. Customer will replace filter. Indoor fan is clean. Indoor fan amps 5.3. Leak searched indoor and outdoor coils and found no leaks. Outdoor RLA rated 17.1 amps actual is 9.3. Outdoor FLA amps rated 1.7 actual is 1.1. Outdoor voltage enhancement system rated 45/10mfd actual is 41.5/9.1. Voltage enhancement system is out of factory spec. Recommend replacing voltage enhancement system.
30 day limited warranty, follow up from last visit, installed replacement gas control system, set to 9.9"WC, cycle several times, operation normal at this point.
30 day limited warranty, follow up from last visit, installed replacement gas control system, set to 9.9"WC, cycle several times, operation normal at this point.
30 day limited warranty, follow up from last visit, installed replacement gas control system, set to 9.9"WC, cycle several times, operation normal at this point.
30 day limited warranty, follow up from last visit, installed replacement gas control system, set to 9.9"WC, cycle several times, operation normal at this point.
Service: found fuel delivery system not opening during ignition sequence. Flipped on off switch multiple times, fuel delivery system worked everytime after flipping switch multiple times. Exaust removal system rated 2.8 amps actual is 2.6. Glow bar .3 amps. Static pressure .6inWC. Indoor heat exchange system has no areas of concern. Leak searched indoor coil and found no leaks. If the system stops working again recommend replacing fuel delivery system. Outdoor refrigerant pumping system passed megaohms test.
Service: found fuel delivery system not opening during ignition sequence. Flipped on off switch multiple times, fuel delivery system worked everytime after flipping switch multiple times. Exaust removal system rated 2.8 amps actual is 2.6. Glow bar .3 amps. Static pressure .6inWC. Indoor heat exchange system has no areas of concern. Leak searched indoor coil and found no leaks. If the system stops working again recommend replacing fuel delivery system. Outdoor refrigerant pumping system passed megaohms test.
Service: found fuel delivery system not opening during ignition sequence. Flipped on off switch multiple times, fuel delivery system worked everytime after flipping switch multiple times. Exaust removal system rated 2.8 amps actual is 2.6. Glow bar .3 amps. Static pressure .6inWC. Indoor heat exchange system has no areas of concern. Leak searched indoor coil and found no leaks. If the system stops working again recommend replacing fuel delivery system. Outdoor refrigerant pumping system passed megaohms test.
Service: found fuel delivery system not opening during ignition sequence. Flipped on off switch multiple times, fuel delivery system worked everytime after flipping switch multiple times. Exaust removal system rated 2.8 amps actual is 2.6. Glow bar .3 amps. Static pressure .6inWC. Indoor heat exchange system has no areas of concern. Leak searched indoor coil and found no leaks. If the system stops working again recommend replacing fuel delivery system. Outdoor refrigerant pumping system passed megaohms test.
Quick and responsive. Fixed problem very efficiently.
Very knowledgeable and courteous
Great Service & Cool Air
EXCELENTSERVICE
Great Service
Great to work with from service call to the sales
Great service
Over price for 1 hour of work, ask other people what their opinion was about this, most said very over priced. I personally think the charge should have been $150.00 or less
Clay is the technician that usually is assigned to my place. He's always prompt and exceedingly helpful, giving me options so that I can choose the best option based on what I can afford and explains those options. As an aside and nothing to do with Clay but this particular problem started late on July 3rd so I'd called for a appointment. It was scheduled for the next day and then I was told it would cost $259, almost 3 times the regular rate despite the fact that I have a contract. Luckiiy the problem righted itself (temporarily) and I was able to reschedule but I was taken aback that when an emergency occurs a contract customer is treated no differently. I could understand an extra $50 or so but to be charged so much more for an emergency seems excessive. As I said this is unrelated to my satisfaction wit Clay.
Gerald, who has been here before, did a thorough job checking everything to forestall any potential problem. He made a few suggestions that will be of great help. I always feel your crew is considerate and have great customer service skills
Sean did not do all the test that were needed for the Problem. Told to Steve Moon about the issue.
Excellent customer service from Hector Martinez
Joe was great. He serviced our three units helping to keep them in good working order. I am not happy about the new contract pricing that almost doubles our present costs. I will be looking at other options to service our three units. We are retired and on a fixed income. There should at be a discount based on the fact that all three units are at one location and require one service tech to do the service on one call.
Rich R.
Port Deposit, MD 21904
Chris C.
Port Deposit, MD 21904
Chris C.
Port Deposit, MD 21904
Tammy A.
Port Deposit, MD 21904
Greg P.
Port Deposit, MD 21904
Chris C.
Port Deposit, MD 21904
Mark G.
Port Deposit, MD 21904
Rich R.
Port Deposit, MD 21904
Greg P.
Port Deposit, MD 21904
Howard M.
Port Deposit, MD 21904
Howard M.
Port Deposit, MD 21904
Howard M.
Port Deposit, MD 21904
Tammy A.
Port Deposit, MD 21904
Clay K.
Port Deposit, MD 21904
Clay K.
Port Deposit, MD 21904
Clay K.
Port Deposit, MD 21904
Clay K.
Port Deposit, MD 21904
Clay K.
Port Deposit, MD 21904
Clay K.
Port Deposit, MD 21904
Clay K.
Port Deposit, MD 21904
Clay K.
Port Deposit, MD 21904
Clay K.
Port Deposit, MD 21904
Clay K.
Port Deposit, MD 21904
Clay K.
Port Deposit, MD 21904
Clay K.
Port Deposit, MD 21904
Review
Review
Review
Review
Review
Review
Review
Review
Review
Review
Review
Review
Review